WARNING
3 Troubleshooting Your PC Workstation
If Your PC Workstation Has a Hardware Problem
If the CD-ROM Drive Has a Problem
Be sure to disconnect the power cord and any telecommunication
cables from your computer before you remove the cover to check the
cable connections or jumper settings.
To avoid electric shock and harm to your eyes by laser light, do not
open the CD-ROM drive enclosure. The drive should be serviced by
qualified service personnel only. Refer to the label on the drive for
power requirements and wavelength. Do not attempt to make any
adjustment to the unit. This PC Workstation is a class 1 laser product.
The CD-ROM Drive Does not Work
Check that the cables have been properly connected.
•
Check that the CD-ROM is inserted in the drive.
•
Check the IDE Devices configuration settings in the Setup program
•
(Advanced > IDE Devices).
Check the Hardware Protection settings in the Setup program
•
(Security > Hardware Protection).
Check the Boot Device Security settings in the Setup program
•
(Security > Boot Devices Security).
Check that the Integrated Bus IDE Adapters item is set to Both in the
•
Setup program (Advanced > IDE Devices).
64
English