Table of Contents
Advertisement
TRENDnet User's Guide
Set your router date and time
Advanced Setup > System > System Time
1. Log into your router management page (see "Access your router management page"
on
page
16).
2. Click on Advanced Setup and click on System, then click on System Time.
3. Next to Set Time Zone, click the drop-down list to select your Time Zone.
4. You can choose one of the following options to set your router date and time:
•
Set the Time – Set your router date and time manually in the Set the Time
section. Click Apply at the bottom of the page to apply the changes then click
Continue on the following page.
Note: Time is specified in 24-hour format.
OR
•
Default SNTP Server (Optional) – Set your router date and time to synchronize
with an SNTP (Simple Network Time Protocol) server address (e.g.
pool.ntp.org). Check the Enable option and enter the SNTP server address in
the Server IP field, (e.g. pool.ntp.org).
© Copyright 2012 TRENDnet. All Rights Reserved.
Note: SNTP servers are used for computers and other network devices to
synchronize time across an entire network.
5. Additionally, you can configure the Daylight Savings Time settings if it applied in your
Time Zone.
Next to Set Daylight Saving (Optional), check the Enable option and click the drop-down
lists to set the annual range when daylight savings time is in effect.
6. Click Apply at the bottom of the page to apply the changes. After the settings have
been applied, click Continue on the following page.
Note: If you would like to discard the changes, click Cancel before you click Apply.
You can verify the time/date settings next to Local Time at the top of the page. Local
Time displays the current date and time set on your router.
TW100-BRF214
17
Advertisement
Table of Contents
