Set Up Quality Of Service (Qos) On Your Router; Port Based - TRENDnet TW100-BRF214 User Manual

TRENDnet User's Guide
•
Trigger Type – Select the protocol requested by the device. TCP, UDP, or you
can select Both to choose both TCP and UDP.
Note: Please refer to the device documentation to determine which ports and
protocols are required.
•
Public Port – Enter the ports or port range to open on your router to forward
to the device. (e.g. 2000-2000 or 2000-2038).
•
Type – Select the protocol for the public ports to open on your router to
forward to the device. TCP, UDP, or you can select Both to choose both TCP
and UDP.
• Note: Please refer to the device documentation to determine which ports and
protocols are required.
• Comment – You can enter a comment for the virtual server to make it more
easily identifiable.
4. Click Add to add the port trigger entry to the list.
5. Click Apply at the bottom of the page to apply the changes. After the settings have
been applied, click Continue on the following page.
Note: If you would like to discard the changes, click Cancel before you click Apply.
To modify an entry, next to the entry under Action in the list, click the notepad icon
and the port trigger fields will populate with the settings of the entry. Modify the
settings and click Modify
To delete an entry, next to the entry under Action in the list, click the trash icon
and click Apply at the bottom of the page.
© Copyright 2012 TRENDnet. All Rights Reserved.
. Then click Apply at the bottom of the page.

Set up Quality of Service (QoS) on your router

Advanced Setup > QoS
The QoS section allows you to configure quality of service features such as port based
rate limiting or DSCP (Differentiated Services Code Point or Diffserv) in order to
prioritize specific types of traffic through your router.

Port Based

Advanced Setup > QoS > Port Based
The port based rate limiting feature allows you to set and control the amount of
bandwidth (kbps) allowed per port.
1. Log into your router management page (see "Access your router management page"
on page 16).
2. Click on Advanced Setup and click on QoS, then click on Port Based.
3. Under Settings, check the Enable Rate Control option to enable port based rate
limiting.
4. Next to each port, enter the amount of bandwidth in kbps to allocate per port.
TW100-BRF214
30