Enable Dynamic Routing On Your Router - TRENDnet TW100-BRF214 User Manual

TRENDnet User's Guide

Enable dynamic routing on your router

Advanced Setup > Routing > Dynamic Routing
You may want to setup your router to route computers or devices on your network to
other local networks through other routers. If other routers support dynamic routing
such as RIP (Routing Information Protocol), you can enable this feature on your router
to automatically learn the required routes to reach those networks. It is required that
the same dynamic routing protocol and version is also enabled on the other routers in
order your router and the other routers to exchange information about the network.
Note: Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see "Access your router management page"
on page 16).
2. Click on Advanced Setup and Routing, then click on Dynamic Routing.
3. Review the dynamic routing settings.
• Enable Dynamic Routing – Check the option to enable dynamic routing or
uncheck to disable dynamic routing.
• Working Mode – Select the operation mode for your router when using
dynamic routing.
Router – Use this mode when using your router to route traffic locally
o
only and not being used for a NAT default gateway to the Internet.
Default Gateway - Use this mode when using your router to route
o
traffic locally and simultaneously used as a NAT default gateway to the
Internet.
© Copyright 2012 TRENDnet. All Rights Reserved.
•
Listen Mode – Click the drop-down list to select which dynamic routing
protocols your router will receive from other router so your router can build
routes to other networks.
Disabled – Disable receiving routing information from other routers to
o
your router.
RIP 1 - Receive routing information from other routers using the RIP
o
version 1 protocol.
Both (RIP1+RIP2) – Receive routing information from other routers
o
using both RIP version 1 & 2 protcols.
RIP 2 – Receive routing information from other routers using the RIP
o
version 2 protocol.
•
Supply Mode – Click the drop-down list to select which dynamic routing
protocols your router will send out to other routers so other routers can
dynamically build routes to your network.
Disabled – Disable sending routing information from your router to
o
other routers.
RIP 1 - Sends out routing information to other routers using the RIP
o
version 1 protocol.
RIP 2 Broadcast – Broadcasts routing information to other routers
o
using the RIP version 2 protocol
RIP 2 Multicast – Sends out routing information via multicast to other
o
routers using the RIP version 2 protocol.
4. Click Add to save the static route then click Apply at the bottom of the page to apply
the changes. After the settings have been applied, click Continue on the following page.
Note: If you would like to discard the changes, click Cancel before you click Apply.
You can view the routes defined in your router in the Routing Table section (Advanced
Setup > Routing > Routing Table). You can click Refresh
TW100-BRF214
to refresh the table.
.
36