Port Mapping - TRENDnet TW100-BRF214 User Manual

4-port fast ethernet firewall router
Hide thumbs Also See for TW100-BRF214:
Table of Contents

Advertisement

TRENDnet User's Guide
Example: To forward TCP port 80 to your IP camera
1. Setup DynDNS service (See DynDNS section).
2. Access TRENDnet IP Camera management page and forward Port 80 (see product
documentation)
3. Make sure to configure your network/IP camera to use a static IP address or you can
use the DHCP reservation feature (see "Set up DHCP reservation" on
Note: You may need to reference your camera documentation on configuring a static IP
address.
4. Log into your router management page (see "Access your router management page"
on
page
16).
5. Click on Advanced Setup and click on NAT, then click on Virtual Server.
6. Click Enabled to turn on the virtual server.
7. Next to Private IP, enter the IP address assigned to the camera. (use the last IP
address number such as 192.168.10.101)
8. For the Private Port, enter the port number 80
9. For Public Port, select the Type as TCP and enter the port number 80.
10 Next to Comment, you can enter a comment for the virtual server to make it more
easily identifiable. (e.g. TRENDnet Camera)
© Copyright 2012 TRENDnet. All Rights Reserved.
10. Click Add to add the virtual server to the list.
11. Click Apply at the bottom of the page to apply the changes. After the settings have
page
20).
been applied, click Continue on the following page.
Note: If you would like to discard the changes, click Cancel before you click Apply.

Port Mapping

Advanced Setup > NAT > Port Mapping
The Port Mapping function is similar to the virtual server function except you cannot
specify a different public port and private port (also known as port redirection). The
ports you specify in Port Mapping are set to be the same for both public and private
ports. Also, in the port mapping section, would will be able to specify multiple ports per
entry instead of one port per entry.
1. Log into your router management page (see "Access your router management page"
on
page
2. Click on Advanced Setup and click on NAT, then click on Port Mapping.
3. Review the port mapping settings.
16).
TW100-BRF214
28

Advertisement

Table of Contents
loading

Table of Contents