Prevent Dos (Denial Of Service) Attacks On Your Network - TRENDnet TW100-BRF214 User Manual

TRENDnet User's Guide

Prevent DoS (Denial of Service) attacks on your network

Advanced Setup > Firewall > DoS
The DoS (Denial of Service) feature allows you to enable advanced firewall protection
for the most common denial of service attacks from the Internet. Denial of service are
typically initiated by hackers or malicious users that are attempting to steal confidential
information or purposely sending repeating false communication requests in order to
stop a system (router, network device, computer) from working or functioning or
significantly reducing a system's performance. Your router supports both DoS detection
and prevention.
1. Log into your router management page (see "Access your router management page"
on page 16).
2. Click on Advanced Setup and click on Firewall, then click on DoS.
© Copyright 2012 TRENDnet. All Rights Reserved.
3. Under Settings, check the Enabled option to enable the feature.
4. Under Options, check the DoS attacks you would you're your router to detect and
prevent. For some types of attacks, you can set the threshold value before your router is
triggered to prevent/deny the specified protocol/traffic.
5. Click OK at the bottom of the page to apply the changes. After the settings have been
applied, click Continue on the following page.
Note: If you would like to discard the changes, click Cancel before you click OK.
TW100-BRF214
33