Table of Contents
Advertisement
TRENDnet User's Guide
Set your router date and time
Configuration > Advanced Setting > System Time
1. Log into your router management page (see "Access your router management page"
on
page
36).
2. Click on Configuration at the top of the page, click on Advanced Setting, and click on
System Time.
3. Next to Time Zone, click the drop-down list to select your time zone.
4. You can choose one of the following options to set the System Time:
•
NTP (Network Time Protocol Server) - Next to Auto-Synchronization, check
the Enable option and click the drop-down list and select on one of the options
to configure your time server. You can choose Auto to set the router to
automatically select a predefined time server or Manual to manually enter a
time server (e.g. pool.ntp.org) that is not listed.
Note: If you do not choose Manual or Auto, choose one of the predefined time
server is the list.
Next to Daylight Saving, check the Enable option and configure Start and End
of your daylight savings duration.
© Copyright 2012 TRENDnet. All Rights Reserved.
Click Save at the bottom of the page to save the changes, then click Sync with
Time Server and wait for a status result.
Note: If you would like to discard the changes, click Undo before you click Save.
OR
•
Sync with your computer time - Click Sync with my PC (Date & Time of your
computer) and wait for a status result, then click Save to save the changes.
5. To verify the current system time, click on Configuration, click on Advanced Setting,
and click Setting Overview to check the system time.
TW100-BRV214
37
Advertisement
Table of Contents
