Indication On Function Number Display Goes Out - Fujitsu FI-6750S Operator's Manual

Chapter 8 Troubleshooting

Indication on Function Number Display goes out.

Has the scanner been left out of operation for a long time
after powered on?
NO
Does the display remain blank even after you have turned
ON the scanner again?
YES
The scanner is in Power Save mode.
Return from Power Save mode by doing one of the following:
YES • Load some paper on the ADF Paper Chute.
• Hit any button on the Operator Panel.
Do not press down the Power button for more than 2 seconds.
This will turn off the scanner.
• Execute a command from the scanner driver.
The scanner operation is normal.
NO
If you cannot solve the problem after taking the measures above, check the items
shown in "8.4 Before Contacting Your Dealer or Scanner Service Provider" (on
page 152), and then contact the dealer where you purchased the scanner or an
authorized FUJITSU scanner service provider.
TOP
Contents
Index
Introduction
Scanner
Overview
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Consumables
Trouble-
shooting
Operational
Settings
Appendix
Glossary
138