Indications On The Function Number Display - Fujitsu FI-6750S Operator's Manual

Chapter 1 Scanner Overview

Indications on the Function Number Display

Indication
8 Blinks only one time upon turning on the scanner.
P Indicates that the scanner has been turned ON and is
being initialized.
1 Indicates that initialization has ended successfully. This
status is called "Ready Status" in which you can perform a
scan.
J Indicates that a recoverable error occurred during scan-
U ning.
"J" or "U" and an "error number" are displayed alternately.
For error details, refer to
133).
After the error has been resolved, you can return to the
Ready Status (see "1" above) by pressing the [Stan/Stop]
or [Send to] button.
E Indicates that an abnormality (device error) occurred in the
F scanner during its initialization or during scanning docu-
C ments.
H "E", "F", "C", "H", "A", or "L" and an "error number" are dis-
A played alternately.
L For details of the errors, refer to
134).
If this error occurs, turn the Main Power Switch OFF and
then ON again. If the error persists after this, contact the
store where you purchased the scanner or an authorized
FUJITSU scanner service provider.
Explanation
"Temporary Errors" (on page
"Device Errors" (on page
TOP
Contents
Index
Introduction
Scanner
Overview
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Consumables
Trouble-
shooting
Operational
Settings
Appendix
Glossary
30