Scanning Does Not Start - Fujitsu FI-6750S Operator's Manual

Chapter 8 Troubleshooting

Scanning does not start.

Did you unlock the Transport Lock?
(Flatbed type)
YES
Is the document loaded correctly on the ADF Paper
Chute?
YES
Is the ADF closed completely?
YES
Is the interface cable connected correctly?
YES
Is the connector for the interface cable broken?
NO
Is the specified SCSI ID correctly set?
(when a SCSI interface cable is used)
YES
Does the scanning start after turning on the scanner
again?
NO
Turn OFF the scanner and unlock the Transport Lock.
For how to unlock the Transport Lock, refer to "Chapter 3 Connecting the Cables"
NO
in the Getting Started.
Reload the document correctly on ADF Paper Chute.
NO
Remove the document in the ADF Paper Chute, open the ADF, and then close it
completely.
NO
Connect the interface cable correctly.
For how to connect the cable, refer to "Chapter 3 Connecting the Cables" in the
NO
Getting Started.
Use a new interface cable and correctly connect it.
YES
Turn off the scanner and the computer, specify a correct SCSI ID. Turn on the
scanner again. Then, restart the computer.
NO
For how to specify the SCSI ID, refer to "Chapter 3 Connecting the Cables" in the
Getting Started.
The scanner operation is normal.
YES
If you cannot solve the problem after taking the measures above, check the items
shown in "8.4 Before Contacting Your Dealer or Scanner Service Provider" (on
page 152), and then contact the dealer where you purchased the scanner or an
authorized FUJITSU scanner service provider.
TOP
Contents
Index
Introduction
Scanner
Overview
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Consumables
Trouble-
shooting
Operational
Settings
Appendix
Glossary
139