Fujitsu FI-6750S Operator's Manual page 40

Chapter 2 Loading Documents
For how to load documents with tabs or non-rectangular documents,
refer to "Loading Documents with Tabs or Non-Rectangular
Documents" (on page 45).
According to the length of your document, slide the Paper
Chute Extension out from the ADF Paper Chute up to the
position where the document can be fully supported.
When scanning plastic cards, take a special care for the
following:
• Place one card at a time on the ADF Paper Chute.
• It is recommended that the front side of the card be
placed face down in the ADF.
• Place the card in the following orientation (portrait).
• Cards to be scanned should satisfy:
ISO7810 type ID-1 type compliant card
Size : 86 mm (height) x 54 mm (width)
(3.39 in. x 2.13 in.)
Thickness : 0.76 ± 0.08 mm (0.030 ± 0.003 in.)
Material : Poly vinyl chloride (PVC) or Polyvinyl
chloride acetate (PVCA)
Before scanning your card, test with a dummy card of
the same material to see if it can be fed into the ADF
properly.
• Embossed cards cannot be scanned.
• Cards that are excessively rigid or stiff may not feed
smoothly.
• Clean off greasy finger prints if any from the surface of
your card before scanning.
• Cards cannot be scanned when the imprinter is
installed.
TOP
Contents
Index
Introduction
Scanner
Overview
Place face down.
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Consumables
Trouble-
shooting
Operational
Settings
Appendix
Glossary
40