Show Ip Igmp Snooping Mrouter - Cisco NM-8B-U - HW ROUTERS L-M User Manual

show ip igmp snooping mrouter

show ip igmp snooping mrouter
To display information on dynamically learned and manually configured multicast router ports, use the show
ip igmp snooping mrouter command in privileged EXEC mode.
Syntax Description
vlan vlan-id
Command Modes
Privileged EXEC
Command History Release
12.0(5.2)WC(1)
12.2(15)ZJ
Usage Guidelines
You can also use the show mac-address-table multicast command to display entries in the MAC
address table for a VLAN that has Internet Group Management Protocol (IGMP) snooping enabled.
Examples
The following is sample output from the show ip igmp snooping mrouter vlan 1 command:
In this example, Fa0/3 is a dynamically learned router port, and Fa0/2 is a configured static router
Note
port.
Switch# show ip igmp snooping mrouter vlan 1
Vlan
----
1
Related Commands Command
ip igmp snooping
ip igmp snooping vlan
ip igmp snooping vlan
immediate-leave
ip igmp snooping vlan mrouter
show mac-address-table multicast
Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
224
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
show ip igmp snooping mrouter [vlan vlan-id]
(Optional) Specifies a VLAN. Valid values are 1 to 1001.
Modification
This command was introduced.
This command was implemented on the following platforms: Cisco 2600
series, Cisco 3600 series, and Cisco 3700 series routers.
ports
-----
Fa0/2(static), Fa0/3(dynamic)
Description
Enables IGMP snooping.
Enables IGMP snooping on the VLAN interface.
Configures IGMP Immediate-Leave processing.
Configures a Layer 2 port as a multicast router port.
Displays the Layer 2 multicast entries for a VLAN.