Cisco NM-8B-U - HW ROUTERS L-M User Manual page 154

Configuration Examples for the 16- and 36-Port Ethernet Switch Module
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
The following is sample output from the show ip interface privileged EXEC command for Gigabit
Ethernet interface 0/2:
Switch# show ip interface gigabitethernet0/2
GigabitEthernet0/2 is up, line protocol is up
Internet address is 192.20.135.21/24
Broadcast address is 255.255.255.255
Address determined by setup command
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Multicast reserved groups joined: 224.0.0.5 224.0.0.6
Outgoing access list is not set
Inbound
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is disabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF Fast switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Probe proxy name replies are disabled
Policy routing is disabled
Network address translation is disabled
WCCP Redirect outbound is disabled
WCCP Redirect exclude is disabled
BGP Policy Mapping is disabled
The following is sample output for the show running-config privileged EXEC command for Gigabit
Ethernet interface 0/2:
Switch# show running-config interface gigabitethernet0/2
Building configuration...
Current configuration : 122 bytes
!
interface GigabitEthernet0/2
no switchport
ip address 192.20.135.21 255.255.255.0
speed 100
mls qos trust dscp
end
Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
154
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
access list is not set