Cisco NM-8B-U - HW ROUTERS L-M User Manual page 134

Configuration Examples for the 16- and 36-Port Ethernet Switch Module
Router(vlan)# exit
APPLY completed.
Exiting....
Router#
EtherChannel Load Balancing Example
•
•
•
Layer 2 EtherChannels Example
The following example shows Fast Ethernet interfaces 5/6 and 5/7 being configured into port-channel 2 with
PAgP mode desirable:
Router# configure terminal
Router(config)# interface range fastethernet 5/6 -7
Router(config-if)# channel-group 2 mode desirable
Router(config-if)# end
EtherChannel Load Balancing Example
The following example shows EtherChannel being configured to use source and destination IP addresses:
Router# configure terminal
Router(config)# port-channel load-balance src-dst-ip
Router(config)# end
Router(config)#
Removing an EtherChannel Example
The following example shows port-channel 1 being removed:
Router# configure terminal
Router(config)# no interface port-channel 1
Router(config)# end
Removing the port-channel also removes the channel-group command from the interfaces belonging to
Note
it.
802.1x Authentication Examples
•
•
•
•
•
Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
134
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Layer 2 EtherChannels Example, page 134
EtherChannel Load Balancing Example, page 134
Removing an EtherChannel Example, page 134
Enabling 802.1x Authentication Example, page 135
Configuring the Switch-to-RADIUS-Server Communication Example, page 135
Enabling Periodic Re-Authentication Example, page 135
Changing the Quiet Period Example, page 135
Changing the Switch-to-Client Retransmission Time Example, page 135