Configuring The Hello Time; Configuring The Forward-Delay Time For A Vlan; Configuring The Maximum Aging Time For A Vlan - Cisco NM-8B-U - HW ROUTERS L-M User Manual

Configuration Tasks
Verifying the Bridge Priority of a VLAN
Use the show spanning-tree vlan bridge command to verify the bridge priority:
Step 1
Router# show spanning-tree vlan 200 bridge brief
Vlan
---------------- -------------------- ---- ---- -----
VLAN200

Configuring the Hello Time

To configure the hello interval for the spanning tree, use the following commands in global configuration
mode:
Command
Step 1
Router(config)# [no] spanning-tree vlan vlan-id
hello-time hello-time
Step 2
Router(config)# end

Configuring the Forward-Delay Time for a VLAN

To configure the forward delay for the spanning tree, use the following commands in global configuration
mode:
Command
Step 1
Router(config)# [no] spanning-tree vlan vlan-id
forward-time forward-time
Step 2
Router(config)# end

Configuring the Maximum Aging Time for a VLAN

To configure the maximum age interval for the spanning tree, use the following commands in global
configuration mode:
Command
Step 1
Router(config)# [no] spanning-tree vlan vlan-id
max-age max-age
Step 2
Router(config)# end
Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
70
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Hello Max Fwd
Bridge ID
33792 0050.3e8d.64c8
Time Age Delay Protocol
--------
2 20 15 ieee
Purpose
Configures the hello time of a VLAN. The hello-time value can
be from 1 to 10 seconds.
Use the no form of this command to restore the defaults.
Exits configuration mode.
Purpose
Configures the forward time of a VLAN. The value of
forward-time can be from 4 to 30 seconds.
Use the no form of this command to restore the defaults.
Exits configuration mode.
Purpose
Configures the maximum aging time of a VLAN. The value
of max-age can be from 6 to 40 seconds.
Use the no form of this command to restore the defaults.
Exits configuration mode.