Cisco NM-8B-U - HW ROUTERS L-M User Manual page 166

debug eswilp
debug eswilp
To enable debugging of Ethernet switch network module features, use the debug eswilp command in
privileged EXEC mode. To disable debugging output, use the no form of this command.
Syntax Description
dot1x
filtermgr
fltdrv
igmp
port-driver
power-supply
span
switch-pm
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.1(6)EA2
12.2(15)ZJ
Usage Guidelines The undebug eswilp command is the same as the no debug eswilp command.
Examples
The following example shows debugging messages for the IGMP snooping services on the Ethernet
switch network module being displayed:
Router# debug eswilp igmp
Related Commands Command
show debugging
Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
166
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
debug eswilp {dot1x | filtermgr | fltdrv | igmp | port-driver | power-supply | span | switch-pm}
no debug eswilp {dot1x | filtermgr | fltdrv | igmp | port-driver | power-supply | span |
switch-pm}
Displays ESWILP 802.1x debugging messages.
Displays ESWILP filter manager debugging messages.
Displays ESWILP filter driver debugging messages.
Displays ESWILP IGMP debugging messages.
Displays ESWILP port driver debugging messages.
Displays ESWILP power supply information debugging messages.
Displays ESWILP SPAN debugging messages.
Displays ESWILP switch port manager debugging messages.
Modification
This command was introduced.
This command was implemented on the following platforms: Cisco 2600
series, Cisco 3600 series, and Cisco 3700 series routers. The dot1x,
filtermgr, and fltdrv keywords were added.
Description
Displays information about the types of debugging that are enabled.