Cisco NM-8B-U - HW ROUTERS L-M User Manual page 211

16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
service-policy
To apply a policy map defined by the policy-map command to the input of a particular interface, use the
service-policy command in interface configuration mode. To remove the policy map and interface
association, use the no form of this command.
Syntax Description
input policy-map-name
Defaults
No policy maps are attached to the interface.
Command Modes Interface configuration
Command History Release
12.1(6)EA2
12.2(15)ZJ
Usage Guidelines Only one policy map per ingress interface is supported.
Service policy maps cannot be defined on egress interfaces.
For more information about configuring access control lists (ACLs), refer to the "Configuring
Note
Network Security with ACLs" chapter in the Catalyst 2950 Desktop Switch Software Configuration
Guide for this release.
Examples
The following example shows how to apply plcmap1 to an ingress interface:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# service-policy input plcmap1
You can verify your settings by entering the show policy-map privileged EXEC command.
Related Commands Command
policy-map
show policy-map
service-policy input policy-map-name
no service-policy input policy-map-name
Modification
This command was introduced.
This command was implemented on the following platforms: Cisco 2600
series, Cisco 3600 series, and Cisco 3700 series routers.
Applies the specified policy-map to the input of an interface.
Description
Creates or modifies a policy map that can be attached to multiple
interfaces to specify a service policy.
Displays QoS policy maps.
Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
service-policy
211