Annual safety check
The assembly and installation of the gas
connection must be performed by a qualified
person who has demonstrated skill and
knowledge related to the construction,
installation and operation of gas appliances and
has received safety training to identify and avoid
the hazards involved.
• For safety reasons, have the device checked
by a qualified person every year for proper
function. Any defects must be repaired.
Replacing the nozzles
The assembly and installation of the gas
connection must be performed by a qualified
person who has demonstrated skill and
knowledge related to the construction,
installation and operation of gas appliances and
has received safety training to identify and avoid
the hazards involved.
• Let a qualified person replace the nozzles
as shown (fig.e - fig.f)).9.4 Gas Cylinders/
Bottles
WARNING: Never operate the appliance
with gas and or at gas pressures different to
those indicated by Dometic as this could cause
irregular and incorrect operation. Dometic
declines all responsibility for damage or injury
caused by an incorrect or improper use of the
appliance.
The appliance runs off standard gas bottles
which can be found in the country of use. The
type of gas to use is clearly marked on the
packaging and on the specifications label affixed
to the rear of the appliance. However always
respect the following instructions: gas bottles
must always be located and positioned in the
compartment provided for this purpose. They
must always be vertical and fitted with a valve
and pressure regulator. Do not obstruct or
impede access to the gas bottle to permit quick
and easy access when replacing.
92
WARNING: When replacing the gas bottle
always take the following precautions:
c. close all gas knobs;
d. make sure there are no flames or fires in
proximity of the gas bottle;
e. close the gas valve on the bottle to be
replaced;
f. unscrew the pressure regulator on the
empty bottle and remove the bottle from
the purpose compartment. This procedure
is inverted for fitting a new bottle. Check
for gas leaks utilising a non-corrosive fluid.
Do not use a water and soap solution.
NEVER USE A FLAME TO CHECK FOR GAS
LEAKS;
g. ignite the burners to check they function
correctly. If there are problems call in an
authorised gas service engineer.
After appliance use always turn off the gas tap
on the bottle
GAS LEAKS:
We recommend the use of an electronic
and homologated gas detector for checking
ambient air.
If there is a smell of gas;
a. immediately open the windows and
evacuate the campervan.
b. do not turn on or off light switches or other
electronic appliances, do not light matches
or lighters or anything that could cause the
gas to ignite;
c. put out any flames
d. shut off the valve on the gas bottle or
cylinder. Do not re-open this valve unless
the gas leak has been identified and
eliminated.
e. contact an authorised gas service
engineer.Cleaning
WARNING: Before cleaning the appliance
always turn it off and disconnect from power
supply and wait until it has cooled down.
Need help?
Do you have a question about the MONZA CAMPERVAN and is the answer not in the manual?
Questions and answers