Swift MONZA CAMPERVAN Owner's Manual page 70

Environmental Readings
The system uses two sensors to measure internal temperature/humidity and external temperature.
The combined internal temperature and humidity sensor is furniture mounted within the vehicle and
plugs into the rear of the control panel, and the external sensor is mounted below the vehicle floor
and plugs into the MC100 unit. The figures displayed are for information only, and it is hoped the
information will be useful.
Water System Operation
The EC940 control panel pump button operates
the internal water pump drawing water from an
on-board tank if fitted, or an external container
when no tank is fitted.
The system incorporates an automatic tank fill
feature. When turned on this will automatically
fill the on-board water tank from the external
container and will switch off automatically when
full. To enable tank fill, press Fill Button on
Fresh Water tank screen. To ensure the external
pump is not damaged if the external tank runs
dry, the pump runs for a maximum of 7 minutes.
The water tanks (fresh & waste) incorporate
a level warning feature to warn the user when
the fresh water level drops below 25% or when
the waste water level reaches 100%. These
Fresh Water Tank screen. Here you can view the on-board fresh water tank level and control water
tank related features.
warnings can be enabled / disabled from the
User Settings screen.
If the water pump power is turned on and the
fresh water level drops to below 25% a warning
beep will be heard and a message will be
displayed on the control panel. To cancel the
warning, press the bell icon.
If the water pump power is turned on and the
waste water level rises to full (100%) a warning
beep will be heard and a message will be
displayed on the control panel. To cancel the
warning, press the bell icon.
These warnings will not be repeated unless the
water pump power switch is turned off and on
again. This is to ensure the warning does not
become a nuisance.
69