Swift MONZA CAMPERVAN Owner's Manual page 54

Precautions
a. Never look for a leak with a flame. Always
use a soap solution or its equivalent when
testing connections. Do not operate any
electrical apparatus whatsoever, especially
light switches. If the leak is not obvious,
the campervan should be evacuated and
qualified personnel consulted.
b. Avoid naked lights when connecting or
changing a cylinder.
c. Check the flexible hose frequently.
d. The gas is heavier than air and therefore
sinks to the lowest point.
e. Keep bottle gas containers outside (and
protected against frost). If they must be kept
inside make sure they are well away from
heat.
WARNING: Do not use appliances with a
different working pressure to 30mbar.
WARNING:Maintain adequate spacing of
combustible materials from sources of heat.
WARNING: Do not use independent
portable gas appliances inside the vehicle.
Cookers shall not be used as heaters
WARNING: A BBQ point inlet valve, if
fitted, must only be used for the connection of
portable LPG appliances.
WARNING: If in doubt, Ask!
Always read individual appliance instructions
Connection
Ensure that the gas regulator hose is correctly
connected to the gas cylinder in gas bottle
compartment and that the hose connection is
tight.
Gas cylinders must be fully located, seated at
the base of the bottles and restrained by the
straps provided in the dedicated compartment
position. Straps are positioned to suit 6kg
bottles.
WARNING: If using cylinders other than
those recommended, the user must ensure
these are adequately supported, ventilation
openings must not be obstructed and the
cylinders must not cause damage to other
fixtures
Open ended gas hoses must always be
protected from dirt and insects.
Before turning on the gas supply at the
regulator, ensure that all gas operated
equipment in the campervan is turned off.
All gas equipment is supplied through a Gas
Manifold System which has individual isolation
taps for each appliance (Fig A), as follows:
i Note: If the campervan is in storage
or not being used for a period of time, we
recommend turning off the gas supply at the
gas bottles.
Flue Installations
All flue installations should be inspected once a
year throughout their length for corrosion. Flues
should be replaced if any sign of perforation
is found. Ensure that the replacement is of an
approved type
WARNING: Where a flue terminates below
the floor it is essential to allow free evacuation
of the products of combustion at all times.
Ensure it is kept clear and the area around it
unobstructed especially by snow.
53