Operating Instructions - WaterLogic WL2000IT Manual

The above picture shows front display and control panel for the Waterlogic WL2000IT Water
Treatment System.
For Cold Water:
For Hot Water:
For Ambient Water: Press Ambient Water Select Button followed by the Dispensing Button (within
NOTE: Default selection mode is Cold Water. Selection will return to default after 3 seconds of
inactivity.
NOTE: Selection indication light will turn red when the Hot Water Select Button is pressed, and will
switch back to the default green within 3 seconds after dispensing the Hot Water.
Cold Water
Select
Dispensing Button
WL2000IT Manual

OPERATING INSTRUCTIONS

Press Cold Water Select Button followed by the Dispensing Button (within 3
seconds).
Press Hot Water Select Button followed by the Dispensing Button (within 3
seconds).
3 seconds).
Hot Water
Select
Selection Indicator Light
Page 10 - Revision:EU-2020-10-13