Operating Instructions - WaterLogic WL2FW FIREWALL Series Manual

The above picture shows front LCD display and control panel for the Waterlogic WL2FW.
For Cold Water: Press Cold Water Select Button followed by the Dispensing Button (within 3
seconds).
For Ambient Water: Press Ambient Water Select Button followed by the Dispensing Button (within
3 seconds).
For Hot Water: Press Hot Water Select Button followed by the Dispensing Button (within 3
seconds).
NOTE: Default selection mode is Cold Water. Selection will return to default after 3 seconds of
inactivity.
NOTE: Selection indication light will turn Red when the Hot Water Select button is pressed, and will
switch back to the default green within 3 seconds after dispensing the hot water.
WL2 FW Manual

OPERATING INSTRUCTIONS

Temperature Indicator Light
Page 10 – Revision EU05-07-17