Operating Instructions - WaterLogic infiniti Operating, Installation And Service Manual

The above picture shows front LED and control panel for the Waterlogic infiniti Water Treatment
System, water treatment systems.
Button
NOTE:
Default selection mode is Cold Water. Selection will return to default after 3 seconds of
inactivity.
infiniti Operating, Installation, and Service Manual

OPERATING INSTRUCTIONS

Cold Water - Press Dispensing Button to start dispensing cold water until
desired fill. Cold Water is the Default Water Selection
Hot Water – Press and Release the Hot Water Selection Button followed
by pressing and holding the Dispense Button.
WARNING! Unit produces Hot Water up to 188°F (87°C). Water
above 125°F (52°C) can cause severe burns or scalding. Keep
unauthorized people and children away from the unit to avoid
accidental dispensing of hot water. Children should not use without
supervision.
Cold Water - Press and Release the Cold Water Selection Button followed
by pressing and holding the Dispense Button.
Operational Use
Page 8 - Revision: 9-15-2016