Related Manuals for WaterLogic WL2 Firewall
Summary of Contents for WaterLogic WL2 Firewall
- Page 1 WL2 Firewall Technical Manual Waterlogic 2 Firewall Technical Manual - Issue B, May 2014...
-
Page 2: Table Of Contents
14. Appliances that are obviously damaged must not be used. Electrical Wiring Diagram 230V - Cold and Ambient 15. The replacement of the UV lamp must be carried out by personnel trained by Waterlogic International Electrical Wiring Diagram 230V - Hot and Cold or their approved distributors. -
Page 3: Machine Overview
The thermostat set point is c) Cold & Hot marked at the back of the machine by a small dot. If the WL2 Firewall UV light fails, then no cold water will be dispensed. - Page 4 The moulded panels are made from recyclable ABS plastic. All the ABS plastic The PCB (Printed Circuit Board) is the control unit for the WL2 Firewall, it is responsible panels are UV resistant and meet the standards of CE and UL. Please note that the for the functions of all the mechanical and electrical parts (24V DC).
- Page 5 SOLENOID VALVE COLD COLD WATER OUT WATER OUT SOLENOID SOLENOID VALVE VALVE SOLENOID VALVE COLD COLD SENSOR SENSOR COLD COLD TANK TANK CONDENSER CONDENSER FILTER FILTER DRYER DRYER COMPRESSOR COMPRESSOR Waterlogic 2 Firewall Technical Manual - Issue B, May 2014...
-
Page 6: Pre Delivery Inspection Procedures (Pdi)
Hot and Cold CAUTION: Only competent trained technicians should work on Waterlogic products. • Waterlogic units may weigh over 25KG. We recommend caution when lifting. • Packing materials could present a trip hazard. Keep them off the floor. IN (Water) •... -
Page 7: Installation Procedures
16. Waterlogic recommend that all units are fully electrically (PAT) tested on site by 1. Mount the WL2 Firewall on a firm flat surface with a 50mm air gap on both sides the commissioning engineer as damage may have occurred during transit to the and top so that it cannot topple or fall from a counter top. - Page 8 17. Check the machine to make sure it is electrically safe. 18. The WL2 Firewall should be sanitised at installation. 19. The WL2 Firewall must not be installed in direct sunlight, adjacent to a heat Fig 1. P-KIT-INSTALLATION source, or in an ambient room temperature above 30°C or below 5°C.
-
Page 9: Operating Instructions
Button 3: select ambient • Never try to fill more than one vessel at a time. water Button 2: select cold Main Dispense Button: water to dispense water from selection Waterlogic 2 Firewall Technical Manual - Issue B, May 2014... -
Page 10: Maintenance And Servicing
2-5 litres of water until you are satisfied with the taste. 1. Isolate the power to the WL2 Firewall by turning off the red switch and removing 16. Turn on the heater and compressor switch and allow the machine to cool and the power cord at the rear of the WL2 Firewall. -
Page 11: De-Scaling
• Rubber gloves. • A container that can hold 5 liters. • A funnel or syringe. • A Phillips / Cross head screwdriver. • De-scale solution. • Non-abrasive antibacterial wipes or cloth. Waterlogic 2 Firewall Technical Manual - Issue B, May 2014... -
Page 12: Technical Specifications And Warranties
Minimum Water 2.5 Bar 2.5 Bar 2.5 Bar 2.5 Bar Pressure Waterlogic has a policy of constant and continual improvement and therefore Maximum Water 3.5 Bar 3.5 Bar 3.5 Bar 3.5 Bar reserves the right to change specifications without prior notice, other than in the Pressure case of significant changes. -
Page 13: End Of Life
ROHS Please note: All Waterlogic machines comply with EC Directive (2002/95/EC) on the Restriction BioCote® is an additional line of defence to protect between cleaning routines, it is of the Use of Certain Hazardous Substances in Electrical and Electrical Equipment not a replacement for your normal cleaning and sanitisation processes. - Page 14 Main PCB Schematic Diagram Main PCB Schematic Diagram Cold only 230V Models Cold and Ambient 230V Models Waterlogic 2 Firewall Technical Manual - Issue B, May 2014...
- Page 15 Main PCB Schematic Diagram Hot and Cold 230V Models Waterlogic 2 Firewall Technical Manual - Issue B, May 2014...
- Page 16 Faucet UV -Sprial Quartz Solenoid Valve DC24V 1000mm JG Equal Elbow Connector 1/4" JG LLD PE Tube - Blue O.D.1/4" JG Equal Elbow Connector 1/4” JG LLD PE Tube - Blue O.D.1/4” Waterlogic 2 Firewall Technical Manual - Issue B, May 2014...
- Page 17 Filter Clip 3" Valved Twist Filter Head 18 19 Filter 21 22 Front Down Panel Front Down Insert Panel Sensor fixing Rubber UV Sensor 15W UV Lamp Firewall UV Lamp Fixing Rubber Waterlogic 2 Firewall Technical Manual - Issue B, May 2014...
- Page 18 Cold Tank Assembly (4 Liters / No UV Holder) JG Equal Elbow Connector 1/4" Main PCB Fixing Bracket Plastic PCB Support Firewall UV Relay PCB (Universal H&C,C&A,CO) FS Silver Side Panel Wire Condenser Waterlogic 2 Firewall Technical Manual - Issue B, May 2014...
- Page 19 JG Equal Tee Connector 1/4" Cushion for Solenoid Valve Mini Firewall Solenoid Valve Fixing Bracket Mini Filter Fixing Panel Valved Twist Filter Head Filter JG Stem Elbow Connector 1/4" * 1/4" Waterlogic 2 Firewall Technical Manual - Issue B, May 2014...
- Page 20 JG Equal Elbow Connector 1/4" Firewall PCB Cover Cold Tank Assembly (4 Liters / No UV Holder) Firewall Display PCB (Universal H&C,C&A,CO) JG Equal Elbow Connector 1/4" Silicon Button Key Mat CA Wire Condenser Waterlogic 2 Firewall Technical Manual - Issue B, May 2014...
- Page 21 Speak to a Water Expert USA, Canada and Mexico exportsales@waterlogic.com info@waterlogicusa.com + 353 1 293 1960 + 1 402 884 7212 WLI Trading Ltd. Waterlogic USA, 11710 Stonegate Circle Suite 4, 2nd Floor Beacon Court, Omaha, NE 68164 Sandyford, Dublin 18, Ireland www.waterlogic.com...
Need help?
Do you have a question about the WL2 Firewall and is the answer not in the manual?
Questions and answers