Operating Instructions; For Cold Water; For Hot Water - WaterLogic WL250 Operating, Installation And Service Manual

The above picture shows front LCD display and control panel for the Waterlogic WL250 Water
Treatment System.
For Cold Water: Press Cold Water Select Button followed by the Dispensing Button (within 3
seconds).
For Hot Water: Press Hot Water Select Button followed by the Dispensing Button (within 3
seconds).
NOTE: Default selection mode is Cold Water. Selection will return to default after 3 seconds of
inactivity.
NOTE: Selection indication light will turn red when the Hot Water Select button is pressed, and will
switch back to the default green within 3 seconds after dispensing the hot water.
WL250 Operating, Installation, and Service Manual Page 8 ‐ Revision: 4‐25‐2016
OPERATING INSTRUCTIONS
Cold Water
Select
Dispensing Button
Selection Indicator Light
Hot Water
Select