Operating Instructions - WaterLogic WL400 Series Manual

The above picture shows front dispensing panel for the Waterlogic WL400 Water Treatment System.
Button
COLD WATER: Press the Cold-Water selection button. There may be a 2
second delay as Firewall™ UV lamp purifies the water and the Firewall™.
Sensor ensures your safety. Blue light will illuminate the dispense area.
AMBIENT WATER: Press the Room Temperature (Ambient) Water
selection button. There may be a 2 second delay as Firewall™ UV lamp
purifies the water and the Firewall™ Sensor ensures your safety. Green
light will illuminate the dispense area.
HOT: Press and hold both the Hot Water 185°F (85°C) and the Extra Hot
Water selection buttons simultaneously for 2 seconds and hot water will
dispense. This is a child safety feature. Red light will illuminate the
dispense area.
EXTRA HOT: Press the Extra Hot Water Selection button to elevate the
hot tank to 203°F (95°C). Allow a few minutes for the temperature to rise
in the hot tank.
Press and hold both the Hot Water and the Extra Hot Water selection
buttons simultaneously for 2 seconds and hot water will dispense. This is
a child safety feature. Red light will illuminate the dispense area.
above 125°F (52°C) can cause severe burns or scalding. Keep
unauthorized people and children away from the unit to avoid
accidental dispensing of hot water. Children should not use without
supervision.
WL400 Manual

OPERATING INSTRUCTIONS

WARNING! Unit produces Very Hot Water up to 203°F (95°C). Water
Operational Use
Page 10 – Revision: 10-23-2019