Snmp User Table - D-Link DGS-3700 Series User Manual

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual

SNMP User Table

This window displays all of the SNMP User's currently configured on the Switch and also allows you to add new users.
To view this window, click Configuration > SNMP Settings > SNMP User Table as shown below:
The following parameters may be set:
Parameter
User Name
Group Name
SNMP Version
SNMP V3 Encryption
Auth-Protocol by
Password
Priv-Protocol by
Password
Auth-Protocol by Key
Priv-Protocol by
password
Figure 2 - 48 SNMP User Table window
Description
An alphanumeric string of up to 32 characters. This is used to identify the SNMP users.
This name is used to specify the SNMP group created can request SNMP messages.
V1 – Indicates that SNMP version 1 is in use.
V2 – Indicates that SNMP version 2 is in use.
V3 – Indicates that SNMP version 3 is in use.
None – Indicates that there is no SNMP V3 Encryption
Password – Indicates that there is SNMP V3 Encryption through a password
Key – Indicates that there is SNMP V3 Encryption through a key.
MD5 – Indicates that the HMAC-MD5-96 authentication level will be used.
SHA – Indicates that the HMAC-SHA authentication protocol will be used.
None – Indicates that no authorization protocol is in use.
DES – Indicates that DES 56-bit encryption is in use based on the CBC-DES (DES-56)
standard.
MD5 – Indicates that the HMAC-MD5-96 authentication level will be used.
SHA – Indicates that the HMAC-SHA authentication protocol will be used.
None – Indicates that no authorization protocol is in use.
DES – Indicates that DES 56-bit encryption is in use based on the CBC-DES (DES-56)
standard.
43