D-Link DGS-3700 Series User Manual page 23

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
Enter the new VLAN Name and Admin. State and click Apply. To edit an entry for IPv4 features click the
corresponding IPv4 Edit button.
The following parameters can be configured:
Parameter Description
Displays the interface being edited.
Interface Name
Enter the name of the VLAN corresponding to the interface.
VLAN Name
Enter an alternative IPv4 address. Currently an interface can only have one IPv4 address defined.
IPv4 Address
Therefore multinetting configuration of IPv4 must be done through creation of a secondary
interface on the same VLAN, instead of directly configuring multiple IPv4 addresses on the same
interface.
Enter the corresponding subnet mask.
Subnet Mask
This function allows user to enable the IPv4 address on the IP interface.
IPv4 State
Click Apply to implement changes made.
To edit an entry for IPv6 features click the corresponding IPv6 Edit button.
The following parameters can be configured:
Parameter Description
Displays the interface being edited.
Interface Name
Enter the name of the VLAN corresponding to the interface.
VLAN Name
IPv6 Network
Enter the IPv6 Network Address to be configured. The interface can have multiple IPv6 addresses
Address defined. Configuration of IPv6 addresses must be done through the command config ipif.
Allows the user to enable or disable the IPv6 state on the interface.
IPv6 State
This field is used to set the interval, in milliseconds that the Switch will produce neighbor
NS Retransmit
solicitation packets to be sent out over the local network. This is used to discover IPv6 neighbors
time (0-
on the local network. The user may select a time between 0 and 4294967295 milliseconds. The
4294967295)
default is 0.
Figure 2 - 7 IPv4 Interface Settings Edit window
Figure 2 - 8 IPv6 Interface Settings Edit window
12