Lldp Port Settings - D-Link DGS-3700 Series User Manual

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual

LLDP Port Settings

This window is used to display the LLDP port settings on the Switch. The ports can be individually configured to send
notifications to configured SNMP trap receivers.
To view this window, click L2 Features > LLDP > LLDP Port Settings
The following parameters can be set:
Parameter Description
From Port /To Port
Use the pull-down menu to select a range of ports to be configured.
Notification
Use the pull-down menu to Enable or Disable each port for sending change notifications to the
configured SNMP trap receiver(s) when an LLDP data change is detected in an advertisement
received on the port from an LLDP neighbor. The notification will include new available
information, information timeout and information updates. The changing type includes any data
update/insert/remove.
Admin Status
This functions controls the local LLDP agent and allows it to send and receive LLDP frames on
the ports.This option contains TX, RX, TX And RX or Disabled.
TX – the local LLDP agent can only transmit LLDP frames.
RX – the local LLDP agent can only receive LLDP frames.
TX And RX – the local LLDP agent can both transmit and receive LLDP frames.
Disabled – the local LLDP agent can neither transmit nor receive LLDP frames.
The defaut value is TX And RX.
Subtype
Used to specify the type of address that will be used either IPv4 or IPv6.
Action
Used to Enable or Disable the advertise management address function based on port.
Address
Enter the IPv4 or IPv6 address as previously specified. For multi IP-addresses, you can enter
any IP or create a new IP interface that you want to add.
Click Apply to implement changes made.
Figure 3 - 67 LLDP Port Settings window
118