Quick Steps For Configuring Gvrp - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring GVRP
3
Port 3 of Switch B receives the advertisement, Switch B creates the dynamic VLAN 50, and Port 3
becomes a member of VLAN 50.
4
Port 2 advertises VLAN 50, but is not a member of this VLAN.
5
Port 1 on Switch A receives the advertisement, creates dynamic VLAN 50. Port 1 becomes a member
of VLAN 50.
The resulting configuration is depicted below:
1
Switch A
Static VLAN: 10, 20, 30
Dynamic VLAN: 50
Note. Every port on a switch is not a member of all the VLANs. Only those ports that receive the
advertisement become members of the VLAN being advertised.

Quick Steps for Configuring GVRP

1
Create a VLAN using the
-> vlan 5 name "vlan-7"
2
Assign a port to the VLAN using the
-> vlan 5 port default 3/2
3
Propagate the VLAN out of the assigned port using the
following command propagates VLAN 5 out of port 3/2:
-> vlan 5 802.1q 3/2
4
Enable GVRP globally on the switch by using the
-> gvrp
5
Enable GVRP on the port by using the
enables GVRP on port 3/2 of the switch:
-> gvrp port 3/2
6
Restrict a port from becoming a member of the statically created VLAN by using the
gvrp static-vlan restrict
ing a member of static VLAN 10:
-> gvrp static-vlan restrict port 3/5 10
OmniSwitch AOS Release 6 Network Configuration Guide
2
Switch B
Static VLAN
Dynamic VLAN: 10, 20, 30, 50
Dynamic Learning of VLAN 50
vlan command. For example:
vlan port default
gvrp port
command. For example, the following command restricts port 3/5 from becom-
Quick Steps for Configuring GVRP
4
3
Switch C
Static VLAN
Dynamic VLAN: 10, 20, 30, 50
command. For example:
vlan 802.1q command. For example, the
gvrp command.
command. For example, the following command
September 2009
5
End Station
Static VLAN 50
page 5-5