Verifying The Mpls Configuration - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring MPLS

Verifying the MPLS Configuration

To display information about the LDP-based MPLS configuration and status for the switch, use the show
commands listed in the following table:
show router mpls status
show router ldp status
show router ldp interface
show router ldp parameters
show router ldp session
show router ldp peer
show router ldp discovery
show router ldp bindings
show router mpls static-lsp
show router mpls interface
show router mpls label
show router mpls label-range
In addition to using the above show commands to verify the MPLS configuration, the following
commands are available to verify MPLS Label Switched Paths (LSPs):
oam lsp-ping
oam lsp-trace
For more information about the use and resulting displays form all of the above commands, see the
Omniswitch CLI Reference Guide.
OmniSwitch AOS Release 6 Network Configuration Guide
Displays the status and other configuration information for the MPLS
instance.
Displays the status and other configuration information for the LDP
instance.
Displays the LDP interface configuration for the switch.
Displays the global LDP parameter values for the switch.
Displays information about LDP sessions.
Displays information about LDP peers.
Displays the discovery status of the LDP Hello adjacencies between the
local router and LDP peers.
Displays the contents of the MPLS Label Information Base (LIB).
Displays the static LSP configuration for the switch.
Displays the MPLS interface configuration for the switch.
Displays the MPLS labels that are exchanged.
Displays the MPLS label ranges, which includes the label type, start and
end label values, aging, and the number of labels available.
Performs an Operation Administration and Maintenance (OAM) in-
band connectivity test for an existing MPLS LSP.
Performs an OAM traceroute for an existing MPLS LSP.
September 2009
Verifying the MPLS Configuration
page 10-41