Quick Steps For Configuring Ldp - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring MPLS
->show router ldp status
LDP Status for LSR ID 10.10.0.7
Admin State:
Created at:
18:38:14,
Last Change:
Import Policies:
Active Adjacencies:
Active Interfaces:
Active Peers:
Addr FECs Sent:
Serv FECs Sent:
Attempted Sessions:
No Hello Err:
Max PDU Err:
Bad LDP Id Err:
Bad Mesg Len Err:
Malformed TLV Err:
Shutdown Notif Sent: 0,
See the "Static LSP and FRR Commands" chapter and the "Label Distribution Protocol Commands" chap-
ter in the OmniSwitch CLI Reference Guide for information about the fields in the above displays.

Quick Steps for Configuring LDP

An LDP interface is required on each router that will participate in the MPLS LSP. The following steps
provide a quick tutorial for configuring LDP interfaces:
1
Configure LDP support on an existing IP interface using the
ters interface command. For example:
-> configure router ldp interface-parameters interface vlan-10
Note. Optional. When an LDP interface is created, global default parameter values are applied to that
interface. To verify the interface configuration use the
->show router ldp interface
LDP Interfaces
Interface
--------------------------------+---+----+------+-----+------+-------+---------
vlan-30
No. of Interfaces: 1
->show router ldp interface detail
LDP Interfaces (Detail)
Interface "vlan-30"
Admin State:
OmniSwitch AOS Release 6 Network Configuration Guide
Up,
03/25/2009 16:08:06,
03/25/2009 16:08:06,
None,
2,
1,
1,
1,
1,
0,
0,
0,
0,
0,
0,
Adm Opr
Up Up
Up,
Quick Steps for Configuring MPLS
Oper State:
Up Time:
Tunn Down Damp Time (sec):
Export Policies:
Active Sessions:
Inactive Interfaces:
Inactive Peers:
Addr FECs Recv:
Serv FECs Recv:
Param Adv Err:
Label Range Err:
Bad PDU Len Err:
Bad TLV Len Err:
Keepalive Expired Err:
Shutdown Notif Recv:
configure router ldp interface-parame-
show router ldp interface
Hello Hold KA
Factor Time Factor Timeout Address
3 15 3
Oper State:
September 2009
Up,
0d
N/A,
None,
2,
0,
0,
2,
1,
0,
0,
0,
0,
0,
0
command. For example:
KA Transport
30 System
Up,
page 10-5