Deleting The Sap - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring VPLS
Configure Static MAC Addresses for SAPs
Configuring a static MAC address entry for a SAP is supported, but is not required. Static MACs associ-
ated with a SAP are classified as local MACs. A local MAC is used by the associated VPLS so that MAC
addresses are not learned on the edge device.
When a static MAC address is configured, a permanent MAC address entry is created in the VPLS
forwarding database (FDB) that is associated with the SAP. A MAC address can participate in only one
static MAC address entry (local or remote) for a specific VPLS.
To configure a static MAC address for a SAP, use the
For example:
-> configure service vpls 100 sap 1/4:50 static-mac 00:2a:95:01:3e:41
Note that static MAC addresses configured on one edge device are not propagated to other edge devices
associated with the same VPLS instance. Each edge device has an independent forwarding database for
the associated VPLS.
To delete a static MAC address entry for the SAP, use the no form of the configure service vpls sap
static-mac command. For example:
-> configure service vpls 100 sap 1/4:50 no static-mac 00:2a:95:01:3e:41
Static MAC addresses for SAP and mesh-SDP bindings are also configurable using OmniSwitch Source
Learning commands. For more information, see the "Source Learning Commands" chapter in this guide.
Enable the SAP
By default, a SAP is disabled at the time the SAP is created. To enable the SAP administrative status, use
the configure service vpls sap shutdown
-> configure service vpls 100 sap 1/4:50 no shutdown
To disable the service, enter the following command:
-> configure service vpls 100 sap 1/4:50 shutdown

Deleting the SAP

To delete a SAP from the switch configuration, use the no form of the configure service vpls sap create
command. For example:
-> configure service vpls 100 no sap 1/4:50
Use the command to display the SAPs configured for the switch. Use the command to display a list of
services and the SAPs associated with each service.
OmniSwitch AOS Release 6 Network Configuration Guide
configure service vpls sap static-mac
command with the no shutdown option. For example:
September 2009
Configuring VPLS Services
command.
page 11-25