Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual page 256

Quick Steps for Configuring VPLS
19
(Optional) Create a Layer 2 port profile to discard GVRP and STP control frames received on access
ports using the configure service l2profile
"discard-stp-gvrp" profile and configure the profile to discard stp and gvrp:
-> configure service l2profile discard-stp-gvrp create stp discard
-> configure service l2profile discard-stp-gvrp gvrp discard
Note that new profiles inherit the default settings for processing control packets; the above commands only
change the settings for STP and GVRP in the specified profile.
20
(Optional) Associate the "discard-stp-gvrp" profile with access port 1/4 using the
port l2profile command. For example:
-> configure service port 1/4 l2profile "discard-stp-gvrp"
See "Verifying the VPLS Configuration" on page 11-32
configuration for the switch.
page 11-6
command. For example, the following commands create the
for information about how to display the VPLS
OmniSwitch AOS Release 6 Network Configuration Guide
Configuring VPLS
configure service
September 2009