Configuring Autonegotiation And Crossover For Combo Ports; Enabling And Disabling Autonegotiation For Combo Ports - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring Ethernet Ports
To configure the duplex mode on a single combo port, enter interfaces, followed by the slot number, a
slash (/), the combo port number, hybrid, either fiber or copper, duplex, and the desired duplex setting
(auto, full, or half). For example, to set the duplex mode on the fiber combo port 23 on slot 2 to full,
enter:
-> interfaces 2/23 hybrid fiber duplex full
To configure the duplex mode on a range of combo ports, enter interfaces, followed by the slot number, a
slash (/), the first combo port number, a hyphen (-), the last combo port number, hybrid, either fiber or
copper, duplex, and the desired duplex setting (auto, full, or half). For example, to set the duplex mode
on fiber combo ports 21 through 24 on slot 2 to full, enter:
-> interfaces 2/21-24 hybrid fiber duplex full

Configuring Autonegotiation and Crossover for Combo Ports

The following subsections describe how to enable and disable autonegotiation (see
Disabling Autonegotiation for Combo Ports" on page
uring Crossover Settings for Combo Ports" on page

Enabling and Disabling Autonegotiation for Combo Ports

By default, autonegotiation is enabled. To enable or disable autonegotiation on a single combo port, a
range of combo ports, or all combo ports on an entire switch (slot), use the
command. (See "Configuring Crossover Settings for Combo Ports" on page 1-26
Note. In the interfaces hybrid autoneg command, the copper keyword is used to configure the copper
RJ-45 10/100/1000 port while the fiber keyword is used to configure the fiber SFP connector.
To enable or disable autonegotiation on all combo ports in an entire switch, enter interfaces, followed by
the slot number, hybrid, either fiber or copper, autoneg, and either enable or disable. For example, to
enable autonegotiation on all copper combo ports on slot 2, enter:
-> interfaces 2 hybrid copper autoneg enable
Note. using the interface hybrid autoneg command to set all combo ports on a switch will not affect the
configurations of the non-combo ports.
To enable or disable autonegotiation on a single combo port, enter interfaces, followed by the slot
number, a slash (/), the combo port number, hybrid, either fiber or copper, autoneg, and either enable or
disable. For example, to enable autonegotiation on copper combo port 23 on slot 2, enter:
-> interfaces 2/23 hybrid copper autoneg enable
To enable or disable autonegotiation on a range of combo ports, enter interfaces, followed by the slot
number, a slash (/), the first combo port number, a hyphen (-), the last combo port number, hybrid, either
fiber or copper, autoneg, and either enable or disable. For example, to enable autonegotiation on copper
combo ports 21 through 24 on slot 2, enter:
-> interfaces 2/21-24 hybrid copper autoneg enable
OmniSwitch AOS Release 6 Network Configuration Guide
Setting Ethernet Combo Port Parameters
1-25) and configure crossover settings (see
1-26) on combo ports.
interfaces hybrid autoneg
September 2009
"Enabling and
"Config-
for more information).
page 1-25