Turning On The Av Controller; Turning On And Standby - Onkyo SC886 - PR Preamplifier / Processor Instruction Manual

Av controller
Hide thumbs Also See for SC886 - PR Preamplifier / Processor:
Table of Contents

Advertisement

Turning On the AV Controller

• North American model
ON/STANDBY
STANDBY indicator

Turning On and Standby

1
2
Remote
AV controller
controller
or
For non-North American models: To completely shut down the AV controller, set the [POWER] switch to the OFF
position ( ).
Up and Running in a Few Easy Steps
To get your system up and running with the minimum of fuss, here's a few pointers to help you configure the AV
controller before you use it for the very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See "Automatic Speaker Setup (Audyssey MultEQ
page 58.
■ Did you connect your TV to an HDMI OUT or COMPONENT
VIDEO MONITOR OUT 1 or 2?
If you did, see "Monitor Out Setup" on page 49.
■ Did you connect a component to an HDMI input,
component video input, or digital audio input?
If you did, see "Video Input Setup" on page 50, "Component Video
Setup" on page 52, or "Digital Audio Input Setup" on page 53
respectively.
■ Did you connect an Onkyo MD recorder, CD recorder, or RI
Dock?
If you did, see "Changing the Input Display" on page 57.
• Other models
ON/STANDBY
STANDBY indicator
POWER
Set the [POWER] switch to the ON position ( ).
(Skip this step if you have the North American model.)
The AV controller enters Standby mode, and the STANDBY indicator comes on.
On the AV controller, press the [ON/STANDBY] button.
On the remote controller, press the [RECEIVER] REMOTE MODE button,
followed by the [ON] button.
The AV controller comes on, the display lights up, and the STANDBY indicator goes
off.
Pressing the remote controller's [ON] button again will turn on any components con-
nected via u.
To turn the AV controller off, press the [ON/STANDBY] button, or press the remote
controller's [STANDBY] button. The AV controller will enter Standby mode. To pre-
vent any loud surprises the next time you turn on the AV controller, turn down the
volume before you turn it off.
®
XT)" on
STANDBY
ON
RECEIVER
Y
HDMI
P
B
P
R
OUT
IN
MD recorder, CD recorder,
TAPE
RI Dock
COAXIAL
OPTICAL
45

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SC886 - PR Preamplifier / Processor and is the answer not in the manual?

Table of Contents