Speaker Settings - Onkyo SC886 - PR Preamplifier / Processor Instruction Manual

First Time Setup—Continued

Speaker Settings

If you change these settings, you must run the auto-
matic speaker setup again (see page 58).
2, 3
1, 5
To use bi-amping, you must change the "Speaker Type"
setting. For hookup information, see page 25.
Notes:
• When bi-amping is used, the AV controller is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
The onscreen menus shown in this manual may be
slightly different from what you see on your TV.
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w] but-
tons to select "2. Speaker
Setup", and then press [ENTER].
The "Speaker Setup" menu appears.
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
3
1
2–4
4
5
Note:
This procedure can also be performed on the AV control-
ler by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Use the Up and Down [q]/[w] but-
tons to select "1. Speaker Set-
tings", and then press [ENTER].
The "Speaker Settings" menu appears.
2–1. Speaker Settings
Speaker Type Normal
MOVE VALUE RETURN RETURN
Use the Up and Down [q]/[w] but-
tons to select "Speaker Type",
and use the Left and Right
[e]/[r] buttons to select:
Normal:
Select this if you've connected your
front speakers normally.
Bi-Amp:
Select this if you've connected your
front speakers for bi-amped opera-
tion.
Press the [SETUP] button.
Setup closes.
SETUP EXIT
55