Table of Contents
Advertisement
Turning On the AV controller
(North American models)
ON/STANDBY
STANDBY indicator
Turning On and Standby
1
2
AV controller
Remote
controller
or
European and Asian models
( ).
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here's a few easy steps to help you configure the AV controller before you use it for the
very first time. These settings only need to be made once.
■ Did you connect your TV to an HDMI output or COMPONENT VIDEO MONITOR OUT?
If you did, "Monitor Setup" on page 44.
■ Run MultEQ XT Room Correction and Speaker Setup—this is essential!
See "Audyssey MultEQ
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see "HDMI Input Setup" on page 49, "Component Video
Input Setup" on page 50, or "Digital Audio Input Setup" on page 51
respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see "Changing the Input Display" on page 55.
(European and Asian models)
ON/STANDBY
STANDBY indicator
POWER
(European and Asian models)
Set the [POWER] switch to the ON position ( ).
On the AV controller, press the [ON/STANDBY] button.
On the remote controller, press the [RECEIVER] button, followed by the
[ON] button.
The AV controller comes on, the display lights up, and the STANDBY indicator goes
off.
Pressing the remote controller's [ON] button again will turn on any components
connected via u.
To turn the AV controller off, press the [ON/STANDBY] button, or press the remote
controller's [STANDBY] button. The AV controller will enter Standby mode. To
prevent any loud surprises when you turn on the AV controller, always turn down the
volume before you turn it off.
: To completely shut down the AV controller, set the [POWER] switch to the OFF position
®
XT Room Correction and Speaker Setup" on page 56.
STANDBY
ON
RECEIVER
HDMI
OUT
IN
MD recorder, CD recorder,
TV/TAPE
RI Dock
43
Advertisement
Table of Contents
