Network Settings - Onkyo SC886 - PR Preamplifier / Processor Instruction Manual

Advanced Setup—Continued
Power Control
To link the power functions of
components connected via HDMI, select "Enable".
Disable: Power Control disabled.
Enable: Power Control enabled.
Notes:
• The
"Power Control"
above "Control" setting is set to "Enable".
• HDMI power control only works with
patible components that support it and may not work
properly with some components due to their settings
or compatibility.
• When set to "Enable", power consumption will
increase.
• Refer to the connected component's instruction man-
ual for details.
TV Control
Set to "Enable" when you want to control the AV con-
troller from an
nected to HDMI.
Disable: TV Control disabled.
Enable: TV Control enabled.
Notes:
• Set to when the TV is not compatible or
"Disable"
when it is unclear whether the TV is compatible or
not.
• The
"TV Control"
above and
"Control"
set to "Enable".
• Refer to the connected component's instruction man-
ual for details.
Note:
After changing the settings of the
, or
Control" "TV Control"
connected pieces of equipment and then turn on
again. Refer to the User's Manuals for all connected
pieces of equipment.
When linking to a TV that conforms to the CEC
standard, the "Monitor Out" setting must be set to
"HDMI Main".
112
-compatible
setting can be set only when the
-compatible TV that is con-
setting can be set only when the
settings are both
"Power Control"
,
"Control"
, turn off the power to all

Network Settings

This section explains how to configure the AV control-
ler's network settings manually.
If your router's DHCP server is enabled, you don't need
to change any of these settings, as the AV controller is set
use DHCP to configure itself automatically by default
(i.e., DHCP is set to Enable). If, however, your router's
DHCP server is disabled, for example, you're using
-com-
static IP addresses, you'll need to configure these set-
tings yourself, in which case, a knowledge of Ethernet
networking is essential.
What's DHCP?
DHCP (Dynamic Host Configuration Protocol) is used
by routers, computers, the AV controller, and other
devices to automatically configure themselves on a net-
work.
1
2
"Power
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
Use the Up and Down [q]/[w] but-
tons to select "7. Hardware
Setup", and then press [ENTER].
The "Hardware Setup" menu appears.
7. Hardware Setup
1. Remote Control
2. Zone2/Zone3
3. Tuner
4. Analog Multich
5. HDMI
6. Network
MOVE ENTER ENTER RETURN RETURN SETUP EXIT