Am Frequency Step Setup (On Some Models); Changing The Input Display - Onkyo SC886 - PR Preamplifier / Processor Instruction Manual

First Time Setup—Continued
AM Frequency Step Setup
(on some models)
For AM tuning to work properly, you must specify the
AM frequency step used in your area. Note that when
this setting is changed, all radio presets are deleted.
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [q]/[w] but-
tons to select "7. Hardware
Setup", and then press [ENTER].
The "Hardware Setup" menu appears.
7. Hardware Setup
1. Remote Control
2. Zone2/Zone3
3. Tuner
4. Analog Multich
5. HDMI
6. Network
MOVE
3
Use the Up and Down [q]/[w] but-
tons to select "3. Tuner", and
then press [ENTER].
The "Tuner" menu appears.
7–3. Tuner
AM Freq Step
4
Use the Up and Down [q]/[w] but-
tons to select "AM Freq Step",
and then use the Left and Right
[e]/[r] buttons to select:
10kHz: Select if 10 kHz steps are
used in your area.
9kHz: Select if 9 kHz steps are used
in your area.
ENTER RETURN EXIT
ENTER RETURN SETUP
9kHz
VALUE RETURN RETURN SETUP EXIT
5
Press the [SETUP] button.
Setup closes.
Note:
This procedure can also be performed on the AV control-
ler by using its [SETUP] button, arrow buttons, and
[ENTER] button.

Changing the Input Display

If you connect an u-capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TAPE IN/OUT
jacks, or connect an RI Dock to the AUX 1 jacks, for u
to work properly, you must change this setting.
This setting can only be changed on the AV controller.
1, 2 1, 2
1 Press the [TAPE] or [AUX 1] input
selector button so that "TAPE" or
"AUX1" appears on the display.
or
2
Press and hold down the [TAPE]
or [AUX 1] input selector button
(about 3 seconds) to change the
setting.
(3 seconds)
Repeat this step to select MD, CDR, or
or
DOCK.
For the TAPE input selector, the setting
changes in this order:
→
(3 seconds)
TAPE MD
DOCK
For the AUX 1 input selector, the set-
ting changes in this order: AUX1
DOCK
Note:
DOCK can be selected for the TAPE input selector or
AUX 1 input selector, but not both at the same time.
→
CDR
→
↔
57