Introduction; Technical Data - Inta HTMWMBCP Installation And Maintenance Instructions Manual

Introduction

This installation guide has been produced for the Infra red wall mounted thermostatic control
mixer. These instructions cover the installation, operation and maintenance. Please read the
enclosed instructions before commencing the installation of this product, please note;
We recommend that the installation is carried out by an approved
installer.
The installation must be carried out strictly in accordance with the Water Supply (Water Fitting)
Regulations 1999 and any local authority regulations.
If in doubt we recommend that you contact WRAS - Water Regulations Advisory Scheme on
Tel: 0333 207 9030, your local water authority - details available on the WRAS website or the
Chartered Institute of Plumbing and Heating Engineers on Tel: 01708 472 791.
All products MUST be re-commissioned to suit site conditions to ensure optimum performance
levels of the product are obtained.
Check Content
Before commencing remove all components from packaging and check each component with
the contents list.
Ensure all parts are present, before discarding any packaging. If any parts are missing, do not
attempt to install your control mixer until the missing parts have been obtained.
Product Range
HTMWMBCP - HTM safe touch infra red thermostatic wall mounted tap battery operated.
HTMWMMCP - HTM safe touch infra red thermostatic wall mounted tap mains operated.
HTMWMBRS -
HTMWMMRS - HTM safe touch infra red thermostatic wall mounted tap mains operated with

Technical Data

This Inta thermostatic mixer is suitable for installations on all types of plumbing systems, including
gravity supplies, fully pumped, modulating combination boiler, unvented water heater and
unbalanced supplies i.e. Cold Mains
Max Dynamic Pressure
Max Static Pressure
Max Inlet Temperature
Pre Set Factory Temp Setting
Max Unbalanced Pressure Ratio
Min Operating Pressure
Min Inlet Temperature
© Intatec Ltd 2016
HTM safe touch infra red thermostatic wall mounted tap battery operated with
removable spout.
removable spout.
Tank Fed Hot.
5 bar Temperature Stability
12 bar Min Temp Differential to
85˚C ensure fail-safe between hot
41˚C cold supplies
5:1 Auto Flush Feature after
1.0 bar 24 hours of none usage
10˚C
2
± 2˚C
10˚C