Aftercare; Removing Spout And Disinfection - Inta HTMWMBCP Installation And Maintenance Instructions Manual

Aftercare

• With all highly polished items, care should be taken not to damage any of the external
surfaces.
• We recommend that to ensure the physical appearance of the product and component parts
that it is periodically cleaned with a soft damp cloth and a mild detergent. The use of abrasive
or solvent cleaners will damage the finish of the product.
• Care should be taken when cleaning the sensor eye not to damage it by using abrasive
cleaners.
• We recommend periodically that the flow straightener is cleaned using a suitable scaling
solvent. Check first it does not affect the plated surface.
• The internal bore of the flow straightener must be periodically wiped using a damp cloth.
• We recommend that this fitting is serviced at least once a year.
• Only use genuine spare parts, the full list is available on request by ringing the Technical
Helpline number on the back page.
Removing Spout
The HTMWMBRS and HTMWMMRS wall mounted taps have a removable spout to assist with
cleaning, disinfection by immersion or sterilisation in an autoclave.
Inta recommend that a replacement spout is available as the tap should not be left without
a spout (HTMSP16XX).
Cleaning, disinfection and sterilisation is only necessary if there is evidence of solid deposits
around the outlet from the tap or a minimum of once per year.
• Ensure the isolation valve in both supplies to tap are in the closed position to prevent
water flow and potential flooding.
© Intatec Ltd 2016
Internal bore
in flow
straightener
11