Timer; Power Supply; Setting Up - LEXIBOOK CG1300 Instruction Manuals

Timer

I. POWER SUPPLY
The clock requires 2 non-rechargeable 1.5V AAA batteries.
Fit with specified batteries only.
Battery Installation:
1. Open the battery compartment underneath the
timer.
2. Insert 2 x 1.5V AAA batteries according to the
diagram in the battery compartment.
3. Close the battery compartment.
4. Turn the timer on.
Do not use rechargeable batteries. Do not recharge the batteries. Remove storage
batteries before recharging. Recharge storage batteries under adult supervision.
Do not mix different types of battery and storage battery, or new and old batteries
or storage batteries. Insert batteries and storage batteries according to the pola-
rity. Remove used storage batteries from game. Do not short-circuit the battery
or storage battery terminals. Fit with specified batteries or similar only. Keep
batteries away from fire. If game remains unused for an extended period, remove
batteries.
Soon after the batteries have been inserted, or if the timer emits an electric shock,
it may need to be RESET. To do this, push a small fine point such as a paper clip
into the RESET hole at the back of the timer.
II. SETTING UP
To turn the timer on or off, press the ON/OFF button briefly. The timer saves the
last selected options as well as the time elapsed before it was switched off and will
show these when switched on again.
To reset the timer to zero, press and hold the ON/OFF button for about 3
seconds.
CG1300 -1350-F/GB/P/I/E 45
45
17/03/04, 10:20