Section 1: Introduction And Safety; Introduction; Read This Manual Thoroughly; Safety Rules - Generac Power Systems Power Zone 410 Owner's Manual

Section 1: Introduction and Safety

Introduction

Thank you for purchasing a Generac Power Systems Inc.
product. This unit has been designed to provide high per-
formance, efficient operation, and years of use when
maintained correctly.
The information in this manual is accurate based on prod-
ucts produced at the time of publication. The manufac-
turer reserves the right to make technical updates,
corrections, and product revisions at any time without
notice.
Power Zone is a registered trademark of GENERAC MO-
BILE PRODUCTS, LLC.

Read This Manual Thoroughly

WARNING
Consult Manual. Read and understand man-
ual completely before using product.Failure
to completely understand manual and prod-
uct could result in death or serious injury.
If any section of this manual is not understood, contact
the nearest Independent Authorized Service Dealer
(IASD) or Generac Customer Service at 1-888-436-3722
(1-888-GENERAC), or visit
ing, operating, and servicing procedures. The owner is re-
sponsible for correct maintenance and safe use of the
unit.
SAVE THESE INSTRUCTIONS for future reference. This
manual contains important instructions that must be fol-
lowed during placement, operation, and maintenance of
the unit and its components. Always supply this manual
to any individual that will use this unit, and instruct them
on how to correctly start, operate, and stop the unit in
case of emergency.

Safety Rules

The manufacturer cannot anticipate every possible cir-
cumstance that might involve a hazard. The warnings in
this manual, and on tags and decals affixed to the unit
are, therefore, not all inclusive. If using a procedure, work
method or operating technique that the manufacturer
does not specifically recommend, verify that it is safe for
others. Also make sure the procedure, work method or
operating technique utilized does not render the equip-
ment unsafe.
Throughout this publication, and on tags and decals af-
fixed to the unit, DANGER, WARNING, CAUTION and
NOTE blocks are used to alert personnel to special in-
structions about a particular operation that may be
Power Zone 410 ® Controller Owner's Manual
(W000100)
www.generac.com for start-
hazardous if performed incorrectly or carelessly. Observe
them carefully. Their definitions are as follows:
DANGER
Indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NOTE: Notes contain additional information important to
a procedure and will be found within the regular text of
this manual.
These safety warnings cannot eliminate the hazards that
they indicate. Common sense and strict compliance with
the special instructions while performing the action or
service are essential to preventing accidents.
Introduction and Safety
(D000001)
(W000002)
(C000003)
5