Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Generac Power Systems NEXUS Remote Monitor
Summary of Contents for Generac Power Systems NEXUS Remote Monitor
- Page 1 Instruction Manual Nexus Remote Monitor www.generac.com or 1-888-GENERAC...
-
Page 2: Table Of Contents
However, there is no guarantee that interfer- APPENDIX ................. 8 ence will not occur in a particular installation. If this equipment Retrofitting the Nexus Remote Monitor into a does cause harmful interference to radio or television reception, Pre-2010 Model Generator ..........8 which can be determined by turning the equipment off and on, FINAL ASSEMBLY DECAL DRAWING ......... -
Page 3: Read This Manual Thoroughly
Safety Rules SAVE THESE INSTRUCTIONS – This manual is in addition to the Owner's Manual for the generator. All warnings and recommendations in the manufacturer's manuals must be strictly adhered to for safe use. SAVE THESE INSTRUCTIONS – The manufacturer suggests that these rules for safe operation be copied and ... -
Page 4: Operation And Maintenance
Safety Rules GENERAL HAZARDS • After installing this home standby electrical system, the genera- tor may crank and start at any time without warning. When this occurs, load circuits are transferred to the STANDBY (genera- • For safety reasons, the manufacturer recommends that the tor) power source. -
Page 5: How To Obtain Service
Wireless Display System It is the operator's responsibility to perform all safety checks, to The Nexus wireless monitor does not have a power switch, the make sure that all maintenance for safe operation is performed monitor automatically powers up when the batteries are inserted. promptly, and to have the equipment checked periodically by Refer to the “Installation”... -
Page 6: Pair/Reset Button
Wireless Display System NOTE: Figure 1 — Remove Control Panel Cover The red, yellow and green LED’s are also utilized during the pairing process. See the “display unit startup” section for details. PAIR/RESET BUTTON The display unit has a Pair/Reset button on the bottom of the enclosure (Figure 11). - Page 7 Wireless Display System Figure 3 — Mount Transceiver Figure 5 - Plug the 4-pin Plug into the Generator Transceiver Module 4 Pin 13. Connect the wire harness that came with the kit as follows: 10. Unplug the existing four pin plug connected to the LED board •...
-
Page 8: Display Unit Startup
Wireless Display System Figure 7 – Remove Plastic Cover Figure 9 – Battery installation 15. Connect the 0 Wire from the wire harness to the 0 location on Pairing the Generator Transceiver with the Display Unit the terminal strip (Figure 8.) 21A. -
Page 9: Re-Assemble The Generator
Wireless Display System Information Label NOTE: The magnets in the display unit activate a magnetic reed switch A write on label has been provided for adding the generator serial in the generator transceiver in step 21. The relative positioning number and dealer information for easy reference (Figure 12.) of the two units needs to be as shown in Figure 10 to activate the magnetic reed switch. -
Page 10: Adding A Second Display Unit To The System
APPENDIX RETROFITTING THE NEXUS REMOTE MONITOR INTO A PRE-2010 MODEL GENERATOR The Nexus Remote Monitor was developed for the 2010 Home Standby product line but is also compatible with several of the 2008 and 2009 Home Standby models. • It is fully compatible with 2008/09 17 and 20kW models with 3 status LED’s on the side panel. -
Page 11: Final Assembly Decal Drawing
Final Assembly Decal Drawing Drawing 0H9609-A ITEM PART NO. QTY. DESCRIPTION 0G7127 CARTON 306 X 227 X 80 0H9607 PE FOAM 0G7161 BATTERY, AAA 0H8075 BASIC WIRELESS 2010H 0H9593 GENERATOR SIDE RF ANNUNCIATOR 0H9608 MANUAL 0G7130 STATIC SHIELDING BAG, 200 X 140 X 0.08mm OG7092 GASKET, 2.0 X 4.0 X 313 084543A... -
Page 12: Warranty
FOR WIRELESS REMOTE MONITOR (for AIR-COOLED GENERATORS) For a period of 180 days from the date of original sale, Generac Power Systems, Inc. (Generac) warrants its wireless remote monitor will be free from defects in materials and workmanship for the items and period set forth below. Generac will, at its option, repair or replace any part which, upon examination, inspection and testing by Generac or a Generac Authorized Warranty Service Dealer, is found to be defective.