Microcom 238B Operator's Manual page 68

Printer Commands
5.2.9 AutoHeader Commands
X 147 Autoheader Command: The STL Autoheader command provides similar
functionality of other printer manufacturers that specify exact placement and
location of blackline media used for registration. This command is a specialty
media handling command that works when the correct media is used. Please
contact your Microcom Corporation representative if you have any questions
regarding the use of this command. When enabled the printer will autoload
and determine the correct header parameters for all subsequent formats
based on the loaded media except for HFM which is the only parameter that
must be included with the format header. The above values may be changed
via the appropriate ^D command with the change being permanent until
another Autoheader or another ^D command changes them.
After executing the Auto-header command, the values that the printer will use
for the header may be observed using the ^D148 command.
When stock is initially loaded the printer will do an auto header to determine
the correct header parameters. After this, when stock is loaded, the printer will
just advance the stock to the correct printing position wasting the first label
unless stock is loaded after a stock out condition. Then the printer will pull the
stock in and print on the first label and clear the error.
0 147 Execute AutoHeader on power-up only.
1 Execute AutoHeader on the next media loading.
2 Execute AutoHeader immediately (after delay, assumes that media is loaded.
3 Execute AutoHeader every time media is loaded.
^A ^D COMMAND
1 148 Show Autoheader Values Command: After the auto header has been
executed, the values that the printer will use for the header may be seen using
the command ^D148 which will be in the form:
HFM = 24
LSX = 832
LSY = 382
WEB = 0
GAP = 25
DPS = 6
LCB = 3
AGD = 1
SPG = 52
OFX = 0
OFY = 0
D91 = 125
b = 594
5-22 238B Operator's Manual - 880053-0101
Chapter 5