Microcom 238B Operator's Manual page 212

^A ^D COMMAND
X 158 Set the Transmissive Dot2Gap Value: This is the distance of the
transmissive sensor, that detects diecut and blow hole registration marks, to
the dot row.
264 203dpi x28
284 203dpi x24m
380 300dpi x28
438 300dpi x24m
x 203dpi 238
x 300dpi 238
468 203dpi 438
730 300dpi 438
X 159 Brownout Reporting: Reports the number of recorded brownout conditions.
0 After a power up, reports the "running" total of detected Brownouts.
1 Clears the "running" total or volatile brownout count
5 Reports the non-volatile brownout count stored in memory
255 Clears the non-volatile brownout count stored in memory
X 162 Set Advance/Retract Speed: This command is used to set the
advance/retract speed of the dispense commands (^D97, ^D98, ^D99, ^D111)
and uses the same speed table as the ^D46 command.
163 Read Current Sensor Status: This command is used to report the current
status of the printer's sensors. This is useful in setup and/or troubleshooting.
164 Generate Data Matrix Barcode: Refer to Chapter 8 for more details.
X 165 Set the Reflective Dot2Gap Value: This is the distance of the reflective
sensor, that detects blackline registration marks, to the dot row.
487 203dpi x28
284 203dpi x24m
720 300dpi x28
438 300dpi x24m
x 203dpi 238
x 300dpi 238
468 203dpi 438
730 300dpi 438
166 Generate 4-State Intelligent Mail Barcode: Refer to Chapter 8 for more
details.
X 170 Enter Autoheader User Mode: See the ^D28 command for more details.
171 Enter Telnet Pass-Through Mode on Xport Ethernet device
X 176 Generate Planet Code Barcode: Refer to Chapter 8 for more details.
X 193 Generate Aztec Barcode: Refer to Chapter 8 for more details.
238B Operator's Manual - 880053-0101 13-21