Microcom 238B Operator's Manual page 203

^A ^D COMMAND
X 63 Text Mode Control: Allows the entry of new text without the ^D2 command
and/or clears all previous text when new text is added.
0 Disable 1 and 2
1 Enable Auto-Print Mode
2 Clear all previous text upon receiving new data.
3 Enable 1 and 2
XX 64 Auto-Print String Count: The ^Axx instructs the printer how many text strings
to accept before printing.
XX 66 Clear Single FORMAT Stored in RAM: The ^Axx specifies which memory
slot to clear (1-128).
70 Clear Commands 73 through 76
71 Load MaxiCode Bar Code Data
XX 73 Load Copies Count: Instructs the printer to print a group of labels. This
command will not increment/decrement serial numbers.
X 74 Infinity Print: Continues to print copies of a format until the power is shut off.
The valid ^Ax values are "1" to enable and "0" to disable this command.
XX 75 Load Label Count: Instructs the printer to print a batch of labels using the
serial number functions if enabled.
XX 76 Load Delay Time Between Labels: The ^Axx specifies the delay time in
1/10ths of a second. Maximum value is 650.
77 Load PDF-417 Bar Code Data
X 78 Set print head number of dots.
448 203dpi; 2"
640 300dpi; 2"
640 203dpi; 3"
960 300dpi; 3"
832 203dpi; 4"
1280 300dpi; 4"
832 203dpi; 4"
1280 300dpi; 4"
832 203dpi; 4"
1280 300dpi; 4"
X 79 Set print head dots/inch (dpi). This command sets the dot density of the
print head. This command MUST be sent BEFORE the # of Dots is set with
the ^D78 command.
0 203 DPI
1 300 DPI
13-12
(448 dots)
(640 dots)
(640 dots)
(960 dots)
(832 dots)
(1280 dots)
(832 dots)
(1280 dots)
(832 dots)
(1280 dots)
238B Operator's Manual - 880053-0101