Default Configurations For Connecting Online; Finsgateway Configuration And Startup - Omron WS02-NCTC1-E - 07-2001 Operation Manual

Default Configurations for Connecting Online

6-1 Default Configurations for Connecting Online
6-1-1 Connecting via Host Link (SYSWAY-CV)
CPU and NC Unit
Default Configuration
1,2,3...
FinsGateway
Configuration and
Startup
6-2

FinsGateway Configuration and Startup

6-2-1 Standard Configuration and Startup Procedure
1,2,3...
68
Online connection enables using the following CX-Position software functions.
• Download to NC
• Upload from NC
• Verify
• Write Flash Memory
• Monitor
• Monitor Units
• Monitor NC Operating Memory Area
• Monitor NC Operating Data Area
• View NC Error Log
The following FinsGateway settings are required to connect the CX-Position
software online to a PC using serial communications (with the Host Link pro-
tocol) and execute the functions in the previous list.
1. Set the NC Unit's unit number (using the front-panel rotary switches)
2. Create the I/O tables (using the CX-Programmer or Programming Con-
sole)
3. Set the DIP switch on the CPU Unit's front panel.
• If using a peripheral port, turn ON pin 4, and set the PC Setup (set Pro-
gramming Console address 144 to the 0000 Hex default, if not already
set to it).
• If using an RS-232C port, turn OFF pin 5, and set the PC Setup (set
Programming Console address 160 to the 0000 Hex default, if not al-
ready set to it).
Refer to 6-2 FinsGateway Configuration and Startup for details.
The following are the standard configuration and startup procedures.
1. From the Start Menu, select Programs/FinsGateway/FinsGateway Con-
figuration.
2. Double-click each communications driver under Networks/Drivers on the
Basic Tab Page and set the required configuration (e.g., the COM Port,
protocol, communications parameters, and other settings). The following
FinsGateway configurations must match the Network Configuration config-
urations set when the PC was added to CX-Position.
FinsGateway
Network number under the Network
Tab's Network
Node... in the Nodes Tab.
Adding a PC to CX-Position
Network Address under Network Settings
Node Number under Network Settings
Section 6-1