Allocation Default Values; Allocation Settings - Omron K3HB - MANUAL 2 Manual

I/O Allocation
Note
4-2-3

Allocation Default Values

4-2-4

Allocation Settings

Allocated Allocated
to IN to OUT
Area Area
−1
No Yes
No Yes Operation command
No No Generic status
Yes No Status
Yes No Measurement value
Yes No Maximum value
Yes No Minimum value
Yes Yes Comparative set value HH (OUT5)
Yes Yes Comparative set value H (OUT4)
Yes Yes Comparative set value L (OUT2)
Yes Yes Comparative set value LL (OUT1)
Yes Yes Comparative set value PASS (OUT3) Comparative set value PASS (OUT3) Default value: 2 bytes
6-4
2. K3HB-DRT Operation Data and Setting Data
Monitor values and setting data with communications addresses that be-
long to the following variable types can be allocated. Duplicate settings are
possible and are processed in ascending order.
C0
C2
Note If items are allocated in the read-only area of the OUT Area, words
are allocated in memory but operate as if they had not been allo-
cated.
3. Output Enable Bits
Output Enable Bits are allocated in the first word of the OUT Area.
When Output Enable Bits are allocated in the IN Area, they are always set
to 0 (OFF).
If data allocated to the IN or OUT Area is changed, use a software reset or
cycle the power to enable the new settings.
The default values for I/O allocations are listed in the following table.
Area
IN Area Measurement value
OUT Area Output Enable Bits
Operation commands
The I/O allocation settings are listed in the following table.
Configurator display
Variable type
Operation monitor data
RUN level
Item
Setting data name
OUT Enabled Bits
Operation command
Generic status
Status
Measurement value
MAX value
MIN value
Comparative set value HH (OUT5)
Comparative set value H (OUT4)
Comparative set value L (OUT2)
Comparative set value LL (OUT1)
Section 4-2
Allocation data size
2 bytes, fixed
Default value: 2 bytes
Default value: 2 bytes
4 bytes, fixed
Default value: 2 bytes
Default value: 2 bytes
Default value: 2 bytes
Default value: 2 bytes
Default value: 2 bytes
Default value: 2 bytes
Default value: 2 bytes